The goal of this project is to design and build a prototype of recoating system for a laser cutting machine to turn it into a selective laser sintering printing machine. This prototype will be used to study new sintering materials and to design, if decided, a SLS 3D printing Machine (Selective Laser Sintering). This project has been developed in the installations and funded by Fundació CIM. The project develops the mechanical design and the electronic system design. Both parts are explained on this paper, so new users can use the machine and can understand the system. With this paper, it is expected that it can be improved in a future to test other parameters and configurations. The paper is divided in three basic blocks that are summed up here: The first block is an introduction to the 3D printing technologies. The most used of them are explained and selective laser sintering is explained in deep. With this block the reader can understand why it is important to develop the SLS technology and what has to be done to improve the machines and the technology. The second block is a discussion on the mechanical design of the machine. The general idea of the machine is explained so the user can understand why the machine is designed in this way. After that, each part is detailed to see how the different mechanical challenges where overtaken. At the end of the block, there is a small calculations section needed on the electronic part. The third block is an extensive explanation of the electronic system that controls and moves the machine. In that block, the different components are explained so the user can understand its basics working principles. It is also explained how the selection of the electronic components was done. Then everything is put together to see the whole electronic system. Along with this paper, there are annexes that provide some extra information for the reader. One of this annexes refers to the mechanical part and the other one has some datasheets and coding for the electronic section. The whole design has been done in SOLIDWORKS cad software and its electric extension ELECWORKS. The programming job was done with Arduino compiler.